10 Misconceptions Your Boss Has About Fiat 500 Replacement Key Cost

fiat 500 duplicate key 500 Replacement Key Fob

It might be time to replace the battery if your 500 remote key fob is not working. If you replace the battery but it doesn't work it could be the issue elsewhere.

At United Locksmith, we specialize in making new keys for old cars. We have all of the necessary tools and parts for this service.

Dead Coin Battery

A dead battery is the most common cause of your Fiat 500 keyfob not locking or unlocking the doors. The key fob has the battery of a coin-cell that is prone to draining quickly when it isn't being utilized frequently enough. If your remote starts to show signs of a loss of range or stopped working and the battery is not working, it could be dead.

Metal clips keep the battery in place inside the key fob. If the clips are loose they can cause contact issues which will prevent the remote from receiving power. Use a flathead screwdriver pry open the retaining clip and remove the battery. Use a battery that has the same voltage, size, and specifications as the original.

Exposure to water can cause the key fob to corrode, or fobik even become damaged. Even a brief shower in soapy water can harm the electronic chip in. Keep your key fob dry.

Water Damage

If your key fob doesn't work correctly, it could be due to water damage. The rubber seals on key fobs keep them from getting damaged by a small drizzle or splash of water. However, it's crucial to keep your keys out of the ocean, washing machine, and even the pool.

The key fob has an electronic chip that transmits a message to the immobilizer system of your car. The chip is what allows the 500 to lock and start. If it gets wet, it will no longer work.

If you're interested in checking if your key fob is still working it is possible to clean the internal electronics using isopropyl or an electronic cleaner. It is recommended to replace the key fob if it is submerged in salt water, rather than trying to repair it yourself.

A replacement fob might cost you a little bit however it's much less expensive than paying to have your fiat ducato key fob 500 towed to a dealership and fixed there! You can also do it yourself with some simple steps. Just make sure you have the right battery type before you attempt to open your key fob. This is a job that's much easier than it looks, and you can find step-by-step instructions online for virtually any key fob in your car.

Faulty Chip

The chip in the key fob communicates to your vehicle's immobiliser to ensure that your car is only able to start when the correct key is inserted. If the chip is damaged, or damaged in any way the car won't start.

A chip that is damaged can happen due to a variety of reasons, but most often it is due to water damage or an unresponsive battery. It is best to leave the job to a professional locksmith who will be able to replace the chip in a short time and at a an affordable cost.

If your key fob will not work after being exposed to clean rain or tap water, remove the battery. Clean the electronic component with a paper towel. If the key fob does not work it's probably a fried chip and will need to be replaced.

Many people will seek out their dealer when they are in need of an entirely new fiat key programmer key fob, however this is a expensive option. If you're looking for a low-cost solution to get your fiat 500 flip key repair key fob fixed, look no further than United Locksmith. We have the tools and knowledge required to repair your fiat key fob replacement fob in a timely and professional manner.

Faulty Receiver Module

Fiat key fobs transmit signals up to 50 feet to the vehicle, which allows it to unlock and lock the doors (and start the vehicle for vehicles with automatic transmissions). There are several reasons why the fob could stop working. This can be caused by a dead coin-battery or water damage, worn-out buttons an issue with the receiver, signal interference or an issue with the chip.

If the fob was placed in a pocket which has suffered extreme trauma (such as being dropped on a hard floor or being washed in the washer) the fob might not be in a position to communicate with the Body Control Module (BCM) of the car. This is because the BCM is an extremely secure system that will only accept signals from a genuine original key and not accept any other.

If this is the case, you will need to replace your fob. A professional locksmith can handle the entire replacement process including programming a brand new key for your 500. They can even provide a clone fob that works exactly like the original (and costs only less than the cost).